Publicidad
Idiomas disponibles
Idiomas disponibles
What to do ...
If the hob does not function correctly, please carry out the
following checks, as it may be something you can remedy
yourself.
...
if the cooking zones will not function?
Check, whether
the main fuse has failed.
D
the appliance is correctly switched on.
D
the safety cut off has operated.
D
the control lamps of the control panel are lighting.
D
the corresponding cooking zone is switched on.
D
the cooking zones are set for cooking as desired.
D
...
if cooking zones cannot be switched on/off?
Check, whether
the control panel is locked.
D
a period of more than 10 seconds has elapsed bet-
D
ween pressing the on/off switch and selecting a coo-
king zone.
the touch controls are entirely or partly covered by
D
liquid or by a wet cloth.
...
if the whole indicator section for residual heat,
except
, will fail all of a sudden?
Check, whether
the ON/OFF touch control
D
ched.
the touch controls are entirely or partly covered by
D
liquid or by a wet cloth.
the safety cut off has operated.
D
there was a power cut for a short while.
D
...
if the displays suddenly go out?
Check, whether
the fuse has failed.
D
there has been a power cut.
D
the setting operation was correctly made.
D
...
if after cooking zone switch- -off the display will
not show
or
for residual heat?
Check, whether
the cooking zone has only been in operation for a
D
short while, and is therefore not hot enough.
...
if a cooking zone cannot be switched on?
Check, whether
the child- -safety
D
...
if all displays (inclusive of residual heat indica-
tor
) go out during cooking?
The overheating protection of the electronic controls
D
has blocked the use of the hob. Once the cooking
zone has cooled down it can be operated again.
was accidentally tou-
is switched on.
...
if the display
If the hob has been used at a high setting for a long
period of time, the overheating protection of the elec-
tronic control will become active and the front left
cooking zone will become inoperable. This occurs to
prevent damage to the electronic controls. The front
left cooking zone will operate again once the ap-
pliance has cooled down and
display. The front right and rear cooking zones can
still be operated during this time.
...
if the display
Check, whether
the touch controls are entirely or partly covered or
D
contaminated by liquid or by a wet cloth.
Clean the ceramic glass surface and wipe it dry.
D
If after switching the appliance back on, the display
D
still shows
Centre.
If after carrying out the above checks your appliance is still
faulty, disconnect from the mains supply and contact your
local Service Force Centre.
In guarantee customers should ensure that the above
checks have been as the engineer will make a charge
if the fault is not a mechanical or electrical break-
down. Please note that proof of purchase is required
for any in- - guarantee service calls.
... the cooking zone automatically switches back
to setting 7 during cooking?
Because the temperature is too high, the electronic
D
control thermal cutoff has triggered an automatic re-
duction of the cooking setting. You can increase the
cooking setting again, after the cookuing zone has
cooled down. If you try to increase the setting again
and the display flashes, this means that it is not yet
possible to carry out the desired increase, because
the appliance is still too hot.
Service and Spare Parts
If you require an engineer or you wish to purchase spare
parts contact your local Service Force Centre by telepho-
ning:
Your call will be routed to the Service Centre covering your
post code area.
When you contact the Service Centre you will need to give
the following details:
1 Your name, address and post code.
2 Your telephone number.
3 Clear and concise details of the fault.
4 Model and serial numer of the appliance (rating plate)
5 The purchase date.
In guarantee customer should ensure that the checks
listed in „What to do" have been made as the engineer will
make a charge if the fault is not a mechanical or electrical
breakdown.
36
flashes?
is no longer in the
lights up?
. Contact your local Service Force
0990- - 929929
Publicidad
