Electrolux ENG7TE75S Manual De Instrucciones página 36

4.10 High temperature alarm
When the temperature in the freezer
compartment increases (for example due to
an earlier power failure), the alarm indicator
flashes, the freezer temperature indicator
shows H° and blinks and the sound is on.
To deactivate the alarm, press any button.
The alarm indicator and sound go off. The
freezer temperature indicator shows H° for 5
seconds before indicating the freezer
temperature again.
The alarm restarts one hour after
deactivation until the normal conditions
are restored.
If you do not press any button, the sound
switches off automatically after around
one hour to avoid disturbing.
4.11 Door open alarm
If the fridge door is left open for
approximately 5 minutes or if the freezer door
is left open for approximately 80 seconds, the
sound is on and the door open alarm
indicator turns on. The internal fridge light
may also start flashing.
The alarm stops after closing the door. Press
any button to switch off the sound.
If you do not press any button, the sound
switches off automatically after around
one hour to avoid disturbing.
4.12 Setting mode
The Setting mode allows you to:
• Enable or disable the ECOMETER
indicator
• Enable or disable the button sounds
• Change the temperature units from °C to
°F
• Reset the appliance to factory settings
Activating the Setting mode
To activate the Setting mode:
1. Press and hold the ECO button for
approximately 3 seconds. When the
36 ENGLISH
Setting mode is being activated, the
display shows a blinking
2. Once the Setting mode is switched on,
the display shows
To deactivate the Setting mode, press and
hold the ECO button for approximately 3
seconds.
The Setting mode deactivates automatically if
you do not interact with the control panel for
60 seconds.
Navigating the Setting mode
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap the fridge temperature button (on the
left) to change the parameter. Tap the
freezer temperature button (on the right)
to change the parameter value.
Display
ECOMETER indicator
In order to switch the ECOMETER on or off:
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap repeatedly. The indicator will
show respectively
for the disabled ECOMETER
indicator.
3. Press and hold the ECO button for
approximately 3 seconds to exit the
Setting mode.
Button sounds
You can enable or disable the button sounds
in the Setting mode. To enable or disable the
sounds:
.
.
.
Default parameters
ECOMETER indicator
Button sounds
Temperature units
Factory settings
.
for the enabled or