Publicidad
Idiomas disponibles
Idiomas disponibles
GB
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Malfunction
Motor does not start.
Motor keeps cutting out.
Cutting blade gets hot.
Smoke development.
Branches are not cut off
cleanly. Branches often
jam in the cutting blade.
Motor running, but the cut-
ting blade does not move.
Appliance vibrates unusu-
ally.
Battery operating time
drops significantly.
Battery cannot be charged. Battery contacts are
28
Cause
Battery is flat.
Battery missing or not in-
serted correctly.
Power supply is interrupt-
ed.
The motor protection
switch has switched off the
motor due to overload.
■
Appliance fault
■
A switch or button is
defective.
No oil on the cutting blade. 1. Switch off the appliance and remove
■
Cutting blade is blunt.
■
Nicks in the cutting
blade.
Cutting blade is blunt.
Sliding play of the cutting
blade is too large.
Appliance fault
Appliance fault
The service life of the bat-
tery has expired.
soiled.
Battery or charger is de-
fective.
Battery is too hot.
Help in case of malfunction
Remedy
Charge the battery.
Install the battery correctly.
1. Remove the battery.
2. Clean the plug contacts of the appli-
ance.
Wait until the motor protection switch en-
ables the motor again.
Contact one of the manufacturer's ser-
vice centres.
the battery.
2. Clean and oil the cutting blade.
3. Install the battery again.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Replace the battery.
Use only genuine accessories from the
manufacturer.
Contact one of the manufacturer's ser-
vice centres.
Order replacement parts. Contact one of
the manufacturer's service centres.
Allow the battery to cool down.
HT 3645 | HT 3660
Publicidad
