Volpi PV220 Manual Del Usuario página 26

Procedure to adjust the opening of the blade:
•
Press the power button. After the LED lights up, press the trigger twice in rapid sequence to open the blades - 100% blade opening.
•
Press and hold the trigger for two seconds. After an acoustic signal - blades open at about 70%.
•
Press and hold the trigger for two seconds. After an acoustic signal - 100% blade opening.
14. Maintenance and cleaning
Tools to be repaired must be sent to Customer Assistance Service.
Use original part keeps the tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining
and repairing the pruning shear, to avoid risk of unexpected
activation of the tool.
•
Keep ventilation, motor and handle cleaning, always use feather clean the device. Do not use cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
•
After continuous work for 8 hours, please open the trigger cover protection of the equipment and clean up wood chips and other impurities
14.1.
Sharpening
•
Sharpening is very important to keep blade in good condition and ensure long life.
•
Always check blade is in good condition before to start work. Of course, the frequency of sharpening depends on the nature of the sheared wood (hardness and
diameter), pruning rate and sharpening tools (special abrasive tools are provided).
Warning!
In particular situations of very hard use, the blade and the handle could reach
high temperatures. It is recommended to handle the pruner with care, using
protective gloves.
Please wear glove before you check the blade is sharp or not, that is
to avoid blade hurt you. Check the pruning shear frequently, this will
keep tool safe and reliableDo not flush the tools or put it in water, it
will cause short circuit or damage the device.
Pag. 26 de 164