Ardo Alyssa Instrucciones De Uso página 9

en
7. Connect one side of the tube (g) – the one without a tube connector – to the membrane cap (f).
8. Connect the other side of the tube (g) to the breastpump using the tube connector (h).
9. Assemble and connect the second collection cup in the same way.
5. Cleaning and disinfection
5.1 Manual cleaning
Before using for the fi rst time and after every subsequent use, dismantle the pumpset into its individual parts and
rinse for at least 1 minute with cold tap water. Then clean using standard washing-up liquid and warm water (not over
+40 °C / 104 °F). Rinse using lots of clean water. Ensure that all washing-up liquid residue is removed. Be careful when
cleaning the valve and the membrane. If they are damaged, there will be no vacuum or only a weak vacuum. Clean the
valve between your thumb and index fi nger using washing-up liquid and warm water (do not use any brushes). Check
the valve for cracks and fraying. Replace the valve regularly and if the vacuum is weak. Leave all parts to air dry on a
clean surface and in a clean location.
The following parts must not be washed or rinsed: tubes (g), tube connector (h), carrying solution.
4