Hotpoint Ariston MWI 122.1 X Manual De Instrucciones página 125

B. Prepare the cabinet
1. Read the instruction on the BOTTOM CABINET TEMPLATE, put the template on the bottom plane of cabinet.
2. Make the marks on the bottom plane of cabinet according to marks "a" of the template
3. Remove the bottom cabinet template and fix the bracket with screw A.
SCREW A
BOTTOM CABINET TEMPLATE
NOTE: IT IS VERY IMPORTANT TO READ
AND FOLLOW THE DIRECTIONS IN THE
INSTALLATION INSTRUCTION BEFORE
INSTALLATION.
This template is used to locate the cabinet
bottom bracket holes "a".
1. Check if your cabinet has a smooth, flat bottom
and right size, and tape the template onto the
bottom plane of cabinet.
- Make sure the CENTERLINE of the template is in
the middle of the cabinet
- Make sure the FRONT EDGE OF template is even
with the cabinet front edge.
2. Make mark on the bottom plane of cabinet
according to the hole "a" of the template.
- Do not drill holes in the bottom cabinet.
3. After make all marks (10 marks) according
to the instructions, remove the bottom
cabinet template.
4. After marking hole "a", continue to install
according to the installation instructions.
CENTER LINE
FRONT EDGE
FRONT EDGE
SCREW A
BRACKET
CENTRE LINE
BRACKET
GB
125