Publicidad
Idiomas disponibles
Idiomas disponibles
Installing
Your Refrigerator
These instructions were provided to aid you in the installation of your unit. Sears cannot be responsible for improper
installation.
How
to Transport
Your
Unit
Follow these tips when moving the unit to final location:
NEVER transport unit on its side. If an upright position is not possible
lay
unit on its back. Allow unit to sit upright for approximately
30 minutes prior
to plugging unit in to assure oil return to the compressor. Plugging unit in
immediately
may cause damage to internal parts.
Use an appliance dolly when moving unit. ALWAYS truck unit from its
side-NEVER
from its front or back.
Protect outside finish of unit during transport
by wrapping cabinet in
blankets or inserting padding between the unit and dolly.
Secure unit to dolly firmly with straps or bungee cords. Thread straps
through handles when possible. DO NOT overtighten. Overtightening
restraints may dent or damage outside finish,
How
to Select
the
Best
Location
Observe these points when choosing the final location for your unit:
How
do I measure
an opening
to insure
proper
fit?
This refrigerator was designed to fit a 69" tall
opening to allow for proper ventilation,
leveling, and door adjustments.
Please also take into account, when
measuring space for your unit, that some
models require a certain amount of
clearance around it to allow for proper air
flow. Proper air flow is key to keep your unit
running a optimum efficiency. To determine
measurements,
please reference the table
below.
m
Z
Subflooring or floor coverings (i.e. carpet tile,
wood floors, rugs) may make your opening
|
smaller than anticipated.
Some clearance may be gained by using the
_1_1
leveling procedure under "How to Level Your
Refrigerator",
DO NOT install refrigerator near oven, radiator, or other heat source. If
that is not possible, shield refrigerator with cabinet material.
DO NOT install where temperature falls below 55°F (13°C). Malfunction
may occur at this temperature.
Make sure floor is level. If floor is not level, shim rear wheels of unit with a
piece of plywood or other shim material.
•
To assure proper door closure, verify that the unit is leveled with a _/f,"tilt
to the back.
How
to
Remove
and
|nstaB
Panels
(some
models)
Reference the sheet entitled Decorator
Door Panel Installation
Instructions
Recommended
Unit Total
Clearance
Volume
Top
Sides
Rear
Less Than 23
N/A
N/A
N/A
cu. Ft
Greater
_';"
NiA
_';"
Than 23 cu Ft.
IMPORTANT: If unit is to be installed into a
recess where top of unit is completely
covered, use dimensions
from floor to top of
hinge cap to verify proper clearance.
shipped on the front of your unit
Publicidad
