Publicidad
Idiomas disponibles
Idiomas disponibles
Hints
and Care
{
How
to Get
the
{\_])j__y Most
Out of
Your Energy
Dollar
• When placing refrigerator into final
position, allow for 1" clearance
around the top and sides of unit to
supply ample ventilation for
optimum energy efficiency.
, Avoid overcrowding
refrigerator
shelves. This reduces effectivity of
air circulation around food and
causes refrigerator to run longer.
• Avoid adding too much warm food
to unit at one time. This overloads
compartments
and slows rate of
cooling.
• Do not use aluminum foil, wax
paper, or paper toweling as shelf
liners. This decreases air flow and
causes unit to run less efficiently.
• A freezer that is 2/3full runs most
efficiently.
• Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances.
If
this is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation,
• Refer to this Use and Care Guide
section on temperature
controls for
recommended
control settings
• Clean door gaskets every three
months according to this Use and
Care Guide's cleaning
instructions.
This will assure that door seals
properly and unit runs efficiently.
• Take time to organize items in
refrigerator to reduce time that door
is open.
• Be sure your doors are closing
securely by leveling unit as
instructed in this Use and Care
Guide.
• Clean condenser
coils as indicated
in the Use and Care Guide every 3
months. This will increase energy
efficiency and cooling performance.
How
to
Remove
and
Replace
Light
Bulbs
/
j,'
I
_
WARNING
]
To avoid electrical
shock which can cause severe personalinjury o r death
disconnect
power to refrigerator before replacing light bulb. After replacing light
bulb, connect power.
I
_
CAUTION
l
To avoid personalinjury or property damage, observe thefollowing:
° Allow light b ulbtocool.
• Wear gloveswhen replacing light b ulb,
#-
Upper
refrigerator
section
1, Locate finger gaps on each side of clear light
shield, insert fingers and press in on each side
of shield. Pull shield down and remove.
2, Remove light bulbs,
O
3. Replace with appliance bulbs no greater
than
"__
40 watts.
4, Replace light bulb cover by inserting front tabs of
/'%'
_l
light shield into slots directly in front of light assembly,
ver and pull straight
F
.-_
II
no greater
than 40
II
_
/Iv
ii
I 4_bs
m)oflight c#_,er into liner slots a nd "_,,..._
_"
Freezer
section
A
1. Remove ice bin by lifting front of bin and pulling out.
2. pullingRernove
,ight bu,b cover by pinching top tab (A) and
[__(_cover
out,
_
_"
_
3, Remove light bulb. Replace with appliance bulb
no greater than 40 watts.
4. Insert bottom tab (B) of light cover into liner slots and snap
B
top portion over light assembly,
5, Replace ice bin by sliding in until bin locks into place.
}
i ce and water dispenser
1, Locate light bulb inside top edge of dispenser frame. Unscrew
to remove.
2. Replace light bulb with a 7-watt, 120 volt bulb.
20
Publicidad
