Exhaust Valve Control Adjustment; Handlebar Adjustment; U-Bolt Position Adjustment - Beta Motorcycles XTRAINER 250 2T EUROPA Manual De Uso

EXHAUST VALVE CONTROL
ADJUSTMENT
ATTENTION! The vehicle is provided
with an exhaust valve whose fine tuning
is performed during the final try-out of the
engine. The position of adjustment valve
1 must not be modified for any reason.
For any adjusting, please contact Betamo-
tor's Authorized Service Network.

HANDLEBAR ADJUSTMENT

U-BOLT POSITION ADJUSTMENT

The lower bracket 1 can be mounted in
correspondence of the holes nr. 2, 3 or
4 respectively.
To adjust the position of the u-bolt remove
the screws shown in the figure.
Remove the handlebar.
Remove the screws 5.
Position the U-bolt according to require-
ments.
At the end refit the screws 5 after the ap-
plication of thread lock fluid and tighten
to the torque indicated.
1
2
3
5
43
1
2
3
4
4
40Nm
3
EN