brondell CIRCLE RC100 Manual De Usuario página 10

PRODUCT INSTALLATION (cont.)
STEP 1: FAUCET INSTALLATION (cont.)
3. Attach the Escutcheon to the Main Body by inserting the
blue tubing through it and pushing it all the way up until
connected to the Main Body.
4. Install the faucet on top of the countertop or sink and feed
the blue tubing through the hole to the cabinet below. Then
slide the large Plastic Washer as shown up through the blue
tubing until snug against the bottom of the countertop or
sink hole. Be sure that the flat part of the Plastic Washer is
facing down and the raised area is facing up as shown here.
5. Install the "Lock Washer" and the "Locking Nut" the same way
and tighten until the plastic washer is holding the faucet
assembly firmly in place. The faucet is now installed!
6. Pull the plastic tab out from the battery compartment to
activate the faucet indicator. The LED light will blink red
once, blue once, and then will be ready to go.
8
3
4
5