brondell CIRCLE RC100 Manual De Usuario página 11

STEP 2: T-VALVE INSTALLATION
1. Turn off the cold water supply under the sink at the wall.
Then, turn on the coldfaucet to drain the residual water
from the water lines.
2. Disconnect cold water supply line from the supply valve
under the sink at the wall.
Install the T-valve on the cold water supply only.
Never connect to the hot water supply!
You may wish to place a bucket or container under
the pipes to catch any excess water.
3. Connect the bottom of the 1/2 inch T-valve to the cold water
supply valve at the wall. If the water connection is a 3/8
inch size, use the provided adapters with rubber washers to
connect the T-valve to the supply line.
4. Re-connect faucet water supply hose to the top of the T-valve
as shown, then insert one end of the orange water supply
tubing into the T-valve 1/4 inch Quick Connector. Be sure to
push firmly into place to secure.
NOTE: See next page for tips on how to use Quick Connectors.
5. Make sure the T-valve is in the closed position (valve arm
should be facing up).
1–2
4
5
9