Electrolux CVLFE46K Manual De Instrucciones página 64

the appliance only with a microfibre cloth
after each use.
Accessories
• Clean all accessories after each use and
let them dry. Use only a microfibre cloth
with warm water and a mild detergent. Do
not clean the accessories in a dishwasher.
• Do not clean the non-stick accessories
using abrasive cleaner or sharp-edged
objects.
11.2 Removing the shelf supports
Remove the shelf supports to clean the
appliance.
1. Turn off the appliance and wait until it is
cold.
2. Carefully pull the shelf supports up and
out of the front catch.
3. Pull the front end of the shelf support
away from the side wall.
4. Pull the supports out of the rear catch.
3
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate or operate the appliance.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The lamp does not work.
The display shows 00:00.
64 ENGLISH
1
2
Install the shelf supports in the opposite
sequence.
11.3 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Top lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Check if...
The appliance is correctly connected to an electrical
supply.
The automatic switch-off is deactivated.
The fuse is not blown.
Lock is deactivated.
The lamp is burnt out.
There was a power cut. Set the time of day.