Roborock S8 MaxV Ultra Manual Del Usuario página 11

C11
Drying
Drying starts automatically after mop
washing or after cleaning is completed.
To manually start or stop drying, tap the
corresponding button in the app.
Notes:
• Stay away from the drying air outlets during drying.
• Drying duration can be modified in the app.
• Auto-drying can be disabled in the app.
C12
Auto Cleaning Solution Addition
The robot will automatically add cleaning
solution to the water for mop washing and
robot water tank refilling according to the
preset ratio to ensure optimal mopping
performance.
Note: Smart Cleaning Solution Filling can be disabled
in the app.
C13
Charging
After cleaning, the robot will automatically
return to the dock to charge.
Press to send the paused robot back
to the dock. The power indicator light will
breathe during robot charging.
Note: If the robot fails to find the dock, it will automatically
return to its starting position. Place the robot on the
dock manually to recharge.
C14
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period, or set whether to enable auto top-
up, emptying and drying, to dim the button
light, or lower the volume of the voice
message during the DND period.
C15
Child Lock
Press and hold to enable/disable Child
Lock. You can also set it in the app. Once
enabled, the robot will not react to button
presses when it is stationary. When the
robot is cleaning or docking, press any
button to pause it.
C16
Error
If an error occurs, the power indicator light
on the robot will flash red or status indicator
light on the dock will be steady red. A pop-
up notification will appear in the app and a
voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
C17
Resetting the System
If the robot does not respond when a button
is pressed or cannot be turned off, reset the
system by pressing the Reset button.
Note: After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
11
C18
Restoring Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
and at the same time, press the Reset
button until you hear the "Restoring
factory settings" voice message. The robot
will then be restored to factory settings.
Routine Maintenance
D
Note: The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
D1
Main Brushes
* Clean every 2 weeks and replace every 6-12 months.
D1-1—Hair-Blocking Rings
D1-2—Main Brush Caps
D1-3—Main Brush Cover
D1-4—Latches
D1-5—Main Brushes
D1-6—Main Brush Bearing
D1-7— Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-8— Pull out the main brushes and
remove the main brush bearings,
main brush caps, and hair-blocking
rings. Remove any entangled hair
or dirt at both ends of the main
brushes. Then, reinstall the hair-
blocking rings, main brush caps, and
main brush bearings.