Roborock S8 MaxV Ultra Manual Del Usuario página 12

D1-9— Reinstall the main brushes. Firmly snap
the main brush bearings into place.
Only after the bearings are securely
installed, fit the main brush cover.
D1-10 Reinstall the main brush cover. Make
—
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a click.
Notes:
• It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
• To prevent injury caused by blades used to cut hair inside
the main brush cover, make sure to install two main
brushes in place before installing the main brush cover.
D2
Flexible Side Brush
* Clean monthly and replace every 3-6 months.
Unscrew the side brush screw. Remove and
clean the side brush. Reinstall the brush
and tighten the screw.
D3
Omnidirectional Wheel
* Clean as required.
D3-1— Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note: The omnidirectional wheel bracket cannot be
removed.
D3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
D4
Main Wheels
* Clean as required.
Clean the main wheels with a soft, dry cloth.
D5
Dustbin
* Clean as required.
D5-1— Remove the magnetic top cover and
press the dustbin latch to take out
the dustbin.
D5-2— Remove the washable filter and
empty the dustbin.
D5-3— Fill the dustbin with clean water and
reinstall the washable filter. Gently
shake the dustbin, and then pour
out the dirty water.
Note: To prevent blockage, only use clean water without
any cleaning liquid.
D5-4— Leave the dustbin and the washable
filter to dry.
D6
Washable Filter
* Clean every 2 weeks and replace every 6-12 months.
D6-1— Remove the filter.
D6-2— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with hands,
brush, or hard objects to avoid potential damage.
D6-3— Allow at least 24 hours for the filter
to dry thoroughly and reinstall it.
Note: Purchase an additional filter and alternate if
necessary.
12
D7
Edgewise Mop Cloth
* Clean as required and replace every 3-6 months.
D7-1— Unscrew the screw in the middle of
the mop cloth.
D7-2— Wash the mop cloth and air-dry it.
D7-3— Reinstall the mop cloth and tighten
the screw.
Note: A dirty mop cloth will affect the mopping
performance. Clean it before use.
D8
VibraRise Mop Cloth
* Clean as required and replace every 3-6 months.
D8-1— Remove the mop cloth from the mop
cloth mount. Clean the mop cloth
and air-dry it.
Note: A dirty mop cloth will affect the mopping
performance. Clean it before use.
D8-2— Slide the mop cloth in from the
opening of the attachment slot, and
then stick it flat in place.
D9
Robot Sensors
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D9-1—Reactive AI Obstacle Recognition
Sensor
D9-2—Dock Locator
D9-3—Carpet Sensor
D9-4—Wall Sensor
D9-5—Communication Sensor
D9-6—Cliff Sensors