Dacor DOP36 86D Serie Manual De Instalación página 21

Installing a 3-wire power cord
WARNING
The neutral or ground wire of the power cord must be connected to the neutral
terminal located in the center of the terminal block. The power leads must be
connected to the lower left and the lower right terminals of the terminal block.
Ground strap
Red
Red
White
White
Black Black
Neutral
terminal
Install_DOP36T86DLS_DG68-01106G-00_EN+MES+CFR.indb 21 Install_DOP36T86DLS_DG68-01106G-00_EN+MES+CFR.indb 21
1. Remove the 3 lower terminal screws
from the terminal block.
2. Insert the 3 terminal screws through
each power cord terminal ring and into
the lower terminals of the terminal
block. Be certain that the center wire
(white/neutral) is connected to the
center lower position of the terminal
block.
3. Tighten screws securely into the
terminal block. DO NOT remove the
ground strap connection.
4. Go to Step 6 on page 23 and proceed
with the installation.
Installing a 4-wire power cord
WARNING
The neutral wire of the supply circuit must be connected to the neutral terminal
located in the lower center of the terminal block. The power leads must be
connected to the lower left and the lower right terminals of the terminal block. The
4th grounding lead must be connected to the frame of the range with the ground
plate and the ground screw.
1.
2.
3.
4.
Ground strap
Ground plate
Neutral Ground wire
terminal (Green)
Red
Red
White
White
5.
Black
Black
Ground
screw
Remove the 3 lower terminal screws
from the terminal block. Remove the
ground screw and ground plate and
retain them.
Cut and discard the ground strap. Do
not discard any screws.
Insert the one ground screw into the
power cord ground wire terminal ring,
through the ground plate, and into the
frame of the range.
Insert the 3 terminal screws (removed
earlier) through each power cord
terminal ring and into the lower
terminals of the terminal block. Be
certain that the center wire (white/
neutral) is connected to the center
lower position of the terminal block.
Tighten screws securely into the
terminal block.
Go to Step 6 on page 23 and proceed
with the installation.
English 21
2023-02-28 오전 10:19:06 2023-02-28 오전 10:19:06