Publicidad
Idiomas disponibles
Idiomas disponibles
Safety / Preparation / Assembly
EXPLOSIVE OR DANGEROUS
LIQUIDS.
WARNING!
MUST NOT BE USED WHEN
PEOPLE ARE IN THE WATER.
Residual risks
WARNING!
LIFE DUE TO ELECTROMAGNET-
IC FIELD.
Under certain conditions, the electro-
magnetic field that develops during
operation can adversely affect active
or passive medical implants.
Consult your doctor or the man-
ufacturer of the medical implants
before operating the appliance.
Preparation
Note: Remove all packaging material from the
product. Remove all protective films before using
the appliance for the first time.
Assembly
Attaching the Adapter and
the Retaining Cable
Press and hold the locking button
Push the connecting piece
connection
completely .
3
Release the locking button
Make sure that the locking button
original position and the connecting piece
is sitting firmly on the pressure connection
Place the non-return valve
opening of the connecting piece
Make sure that the UP label is visible from the
outside.
Screw the adapter
ing piece
counter-clockwise .
12
Fasten the retaining cable
handle
.
1
22 GB/IE/NI/CY/MT
THE PUMP
DANGER TO
.
1 1
onto the pressure
12
.
1 1
is in its
1 1
3
in the connection
10
.
12
firmly onto the connect-
9
to the Carrying
13
Attaching the Pressure Hose
or Pressure Cable
Pressure hose and/or pressure pipe
as well as additional accessories (e.g.
hose clamps) are not included in
delivery.
• Use a pressure hose when the
• Use a pressure pipe with non-re-
The adapter must be trimmed in order
to perform the following steps. Read
through the application options
carefully before trimming the
adapter.
Attaching the Pressure Hose ½"
Push a suitable hose clamp onto the pressure
hose.
Plug the pressure hose onto the adapter
Push the hose clamp so that it comes to rest
upon the pressure hose and the adapter piece.
Tighten the hose clamp.
Attaching the Pressure Hose ¾"-,
1"- or 1 ½"
Trim the adapter
better flow rate.
Using a saw (not included in delivery), cut off
the connection to the adapter
Stick a suitable hose clamp onto the pressure
hose.
Plug the pressure hose onto the adapter
Push the hose clamp so that it comes to rest
12
upon the pressure hose and the adapter piece.
.
Tighten the hose clamp.
Attaching the Pressure Hose Con-
nection System 33.3 mm (G 1")
Using a saw (not included in delivery) cut the
adapter
9
thread.
If necessary, deburr the interface with the aid
of a file or sandpaper.
pump is being operated in an
unfixed installation setting.
turn valve to operate the pump in
a permanent installation setting.
to achieve a
9
resting upon it.
9
off directly above the G 1"-pipe
.
9
.
9
Publicidad
