Publicidad
Idiomas disponibles
Idiomas disponibles
• Reposition the sleeve onto the handle and tighten the
clamp F1.
5.6
REPLACING THE CABLE WITH CENTRAL
ADAPTER.
Remove spring P and cut the clamps that fasten the
cable J. Open the cover W by unscrewing the 4 set
screws and then screw M. Remove pins of the control
cable X and Z. Take note of the position of each pin and
then remove the U-bolt T and the pins of the pilot arc red
cables Y and Y1. Cut the isolating hose K2 and unscrew
body N from fitting I1. Assemble the new fitting and fol-
low the previous instructions in reverse direction. Use
thread sealer to lock the N body thread. To avoid jeopar-
dizing the safety efficiency, the body contacts N must be
connected as follows: pins Y and Y1 of pilot arc red
cables to contacts 5 and 6, pin X of cable J to contact 1,
pin Z of cable J to contact 9.
Reconnect U-bolt T as described above.
10
fig. 7
fig. 8
fig. 9
J
P
AB
AC
W
5.7
WARNINGS
Periodically make sure that the welding torch cable is
intact and has no cuts or excessive wear. Replace it
immediately if needed.
T
X
Z
M
I1 Y
Y1 K2
fig. 10
N
Publicidad
