Acqua Brevetti BravoMATIC Manual De Instrucciones página 30

A1.7 Characteristics of the water to be treated
BravoMATIC has been designed and built for treating water intended for human consumption.
BravoMATIC is not designed to filter closed circuit water, water containing large quantities of
sand or coarse bodies larger than 2 mm, silt or chemicals (oils, solvents, acids, bases, glycols).
For applications other than the ones expressly described herein, it is necessary to contact
Acqua Brevetti SRL (telephone: +39.049.8973432, e-mail: info@acquabrevetti.it) before performing the
installation.
A1.8 Precautions for use
BravoMATIC is a piece of equipment connected to 220 Volt power supply. The plug has to be
inserted into a standard socket, provided with a ground contact and protected by a residual
current circuit breaker. Check that the plug is firmly inserted into the socket and located in a
protected area, away from accidental contact, water splashes, humidity and heat sources. To
perform any intervention, disconnect the filter from the power supply.
A1.9 Power supply connection
Insert the power connection plug into the hole on the right (as shown in the figure).
When the filter is switched on, if it is not in the correct position, it performs a maneuver to position itself in
the filtration position.
In the event of a power failure, the filter retains the last programmed setting when it is switched on again.
BravoMATIC - ENGLISH
MAN139 PAGE E-3