Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
Receiver
Button PAIR
– serves for pairing transmitter with receiver
Button RESET
– initialisation of device after settings change or malfunction of the foot controller.
LED1 (ON/RCV)
– indicates connection to the power voltage and either detection of transmitting commands from the
transmitter
LED2 (BATTERY) - indicates the charge status of the transmitter accumulators
The possible states of charge of the accumulators (LED2):
Solid green – battery is fully charged
Steady orange – battery is partially discharged
Steady red – battery is nearly discharged
Blinking red – it is necessary to recharge the battery
Procedure for charging the battery of the foot controller:
1. Pull out the receiver from the terminal.
2. Connect the battery charging cable of the foot controller to the terminal instead of the signal receiver
3. Connect the other end of the cable to the terminal on the back of the foot controller
4. Charging is indicated by the flash symbol on the battery indicator on the doctor's control panel display
5. The battery is fully charged when the flash symbol disappears from the battery indicator of the display
6. Disconnect the cable from both terminals
7. Connect the receiver to the terminal
If an error occurs on the transmitter during operation, the signal disappears and the receiver does not receive
a new or confirming signal within 2 seconds, the receiver automatically sends the signal as a pedal in the zero
position and interrupts the operation of the currently used instrument.
Pairing the receiver and the transmitter:
Each transmitter has a unique address set by the manufacturer. The transmitter comes from the production
paired with a receiver. Should it happened that the transmitter is not paired with the receiver (when the
instruction is sent from the foot controller, LED1 is not blinking) or in case of the foot controller or receiver
replacement, it is necessary to pair the foot controller with the receiver first.
The setting must be performed by the service technician in accordance with the Instructions for Service.
UM_EN_TYGI350B_2018-09_ver1.0
TYGI 350 B
39 / 49
Publicidad
Capítulos
