Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting the attachment
to/removing the
attachment from the
protective cover
Fitting the attachment
1. If necessary, remove the disc for better
access, see "Installing/changing disc".
2. Fit the attachment (11) onto the guard
cover (7).
3. Push the attachment (11) onto the guard
cover (7) until it clicks into place.
Removing the attachment
1. If necessary, remove the disc for better
access, see "Installing/changing disc".
2. Release the attachment (11) by pushing
the notch (17) away from the guard
cover (7).
3. Unscrew the attachment (11) from the
guard cover (7).
Installing/changing disc
1. Press the spindle stop button (9).
2. Turnthemountingspindle(14)untilthe
spindlelockfi xedthemountingspind-
le. Keep and continue to hold down
the spindle lock button (9)
3. Release the clamping nut (13) with the
chuck key (10). You can release the
spindle lock button (9).
4. Set the desired disc onto the mounting
fl ange(
12). label on the disc
should always face the device.
If the rotary direction is in-
dicated on your disc, ensure
that it corresponds to the
rotary direction of the angle
grinder when mounting. This
is indicated on the device
below the spindle stop but-
ton (9) (
).
Ensurethatthefl ange(
placed on the device in such a way
thattherecessesinthefl angegrip
intotheedgeofthedevice.The
mounting spindle (14) must turn simul-
taneouslywhenyouturnthefl ange.
5. Set the clamping nut (13) on the moun-
tingspindel(14)again.Thefl atsideof
the clamping nut must face the attach-
ment tool if the thickness of the disc
receptor is < 5 mm.
If the thickness of the disc receptor is
≥5mm,turntheclampingnut.
See illustration
6. Press the spindle stop button (9) and
turn the mounting spindle (14), until the
spindle toggle button holds the spind-
lefl angeinafi xedposition.Pullthe
clamping nut (13) tight again using the
chuck key (10). You can let go of the
spindle lock button (9).
Installing/changing the
wire brush
1. Press the spindle stop button (9).
2. Turnthemountingspindle(14)untilthe
spindle stop button holds the mounting
spindleinafi xedposition.Keepthe
spindle stop button (9) depressed.
3. Release the wire brush with a combina-
tion wrench (not included in the scope
of delivery). You can now release the
spindle stop button (9).
4. Place the desired wire brush onto the
mounting spindle.
5. Press the spindle stop button (9) and
rotate the wire brush on the mounting
spindle(14).Tightenthewirebrush
using a combination wrench. You can
now release the spindle stop button (9).
GB
MT
12) is
.
39
Publicidad
