Parkside PWSA 20-Li D4 Traduccion Del Manual De Instrucciones Originale página 41

Checking the charge level of
the rechargeable battery
The­battery­charge­level­indicator­
the battery (5) indicates the charge level of
the battery.
The­charge­level­of­the­battery­is­indicated­
by illumination of the corresponding LED
light. Press the button for the charge level
indicator on the battery.
Red-amber-green => battery fully char-
ged
Red-amber => battery approx. half
charged
Red => battery needs to be charged
Selecting the speed
The­device­has­6­levels,­which­can­be­set­
on the speed regulator (6).
1: 2500 min -1
2: 4000 min -1
3: 5500 min
-1
Turning on and off
To­switch the device on, sli-
1.
de the On/Off switch (3) to
the side and then forwards in the di-
rection of the arrow.
2.­ To­switch it off, release the On/Off
switch.­The­device­switches­off.
If you have switched on continuous
operation, tap the On/off switch (3) at
the back to switch the device off.
After switching on the device, wait until the
device has reached its max. speed. Only
then should you start with the work.
on
4: 7000 min -1
5: 8500 min -1
6: 11.500 min
-1
The tool still runs even after
the device has been switched
off. Risk of injury.
If the disc is blocked for
more than 3 seconds, the
device switches off automati-
cally. If blocked for less than
that, the disc starts back up
automatically.
Trial run:
Always carry out a trial run without a load
before­carrying­out­your­fi ­ rst­procedure­
as well as after every tool change. Switch
the device off immediately if the tool is not
rotating smoothly, if considerable vibration
occurs, or if you hear abnormal noises.
Continuous operation
1.­ Turn­on­the­device.
Switching on continuous opera-
tion:
2. Push the front of the on/off switch (3)
towards the device in the on position.
The­on/off­switch­makes­an­audible­
click.
Switching off continuous ope-
ration:
3. Press the back of the on/off switch (3)
briefl ­ y­once.­The­on/off­switch­will­
spring­back­into­its­initial­position.­The­
device turns off.
Cleaning and servicing
Remove the battery from the device
before carrying out any adjust-
ments, maintenance or repair work.
Have any work on the device
that is not described in this
instruction guide performed
GB MT
41