Descargar Imprimir esta página

Axxess AXDIS-TY2 Instrucciones De Instalación página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

PROGRAMMING THE AXDIS-TY2
6. Once the vehicle has been auto detected by the interface, the LED will turn on solid Green
indicating programming was successful.
7. Test all functions of the installation for proper operation, before reassembling the dash.
8. If the interface fails to function, refer to Resetting the AXDIS-TY2.
Note: The LED will turn on solid Green for a moment, and then turn off under normal
operation after the key has been cycled.
Note: Fade control will not be retained with this interface.
AUDIO LEVEL ADJUSTMENT
(amplified models only)
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counter clockwise to lower the audio level.
3. Once at a desired level, audio adjustment is complete.
STEERING WHEEL CONTROL SETTINGS
(CONT)
LED Feedback Legend: The (23) Red LED flashes represent a different radio manufacturer for the SWC
interface to detect. For example, if you are installing a JVC radio, the SWC interface will flash Red (5) times,
then stop. Following is the LED Feedback Legend, which indicates the flash count of the radio manufacturer.
LED Feedback Legend
KEYNOTES
* If the SWC interface
flashes Red (7) times,
and an Alpine radio
is not installed, that
means there is an
open connection not
accounted for. Verify
that the 3.5mm jack is connected to the correct steering wheel jack/wire in the radio.
** The AXSWCH-PAR is required (sold separately). Also, the software in the radio must be rev. 2.1.4 or higher.
† If a Clarion or Eclipse radio is installed and the steering wheel controls do not function, change the radio to
Clarion (type 2) or Eclipse (type 2) respectively. If the steering wheel controls still do not function, refer to
the Changing Radio Type document available at
‡ If a Kenwood radio is installed and the LED feedback flashes (5) times instead of (2), manually change the radio
type to Kenwood. To do this, refer to the Changing Radio Type on next page.
Flash Count
Radio
Flash Count
1
Eclipse (type 1) †
2
Kenwood ‡
3
Clarion (type 1) †
4
Sony / Dual
5
JVC
6
Pioneer / Jensen
7
Alpine *
8
Visteon
9
Valor
10
Clarion (type 2) †
11
Metra OE
12
Eclipse (type 2) †
axxessinterfaces.com.
REV. 4/23/24 INSTAXDIS-TY2
Radio
13
LG
14
Parrot **
15
XITE
16
Philips
17
TBA
18
JBL
19
Insane
20
Magnadyne
21
Boss
22
Axxera
23
Axxerra (type 2)
24
Alpine (type 2)
5

Publicidad

loading