Axxess AXDIS-TY2 Instrucciones De Instalación página 7

Note: If the next function on the list is not on the steering wheel, press the Volume-Up button
for (1) second until the LED comes on, and then release the Volume-Up button. This will tell
the AXDIS-TY2 that this function is not available and it will move on to the next function.
5. To complete the remapping process, press and hold the Volume-Up button on the steering
wheel until the LED in the AXDIS-TY2 goes out.
Button Assignment Legend
Function # Function
1 Volume-Up
2 Volume-Down
3 Seek-Up/Next
4 Seek-Down/Prev
5 Source/Mode
6 Mute
7 Preset-Up
8 Preset-Down
9 Power
* Not applicable in this application
Note: Not all radios will have all of these commands. Please refer to the manual provided with the
radio, or contact the radio manufacturer for specific commands recognized by that particular radio.
STEERING WHEEL CONTROL SETTINGS
Function # Function
10 Band
11 Play/Enter
12 PTT (Push to Talk)
13 On-Hook
14 Off-Hook
15 Fan-Up *
16 Fan-Down *
17 Temp-Up *
18 Temp-Down *
(CONT)
Dual Assignment Instructions (Long Button Press)
The AXDIS-TY2 has the capability to assign (2) functions to a single button, except Volume-Up
and Volume-Down. Follow the steps below to program the button(s) to your liking.
Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and Preset-Down
for a long button press.
1. Turn on the ignition but do not start the vehicle.
2. Press and hold down the steering wheel control button that you want to assign a long press
function to for about (10) seconds, or until the LED flashes rapidly. At this point release the
button; the LED will then go solid.
3. Press and release the Volume-Up button the number of times corresponding to the new
button number selected. Refer to the Dual Assignment Legend. The LED will flash rapidly while
the Volume-Up button is being pressed, and then go back to a solid LED once released. Go to
the next step once the Volume-Up button has been pressed the desired number of times.
Caution: If more than (10) seconds elapses between pressing the Volume-Up button, this
procedure will abort, and the LED will go out.
4. To store the long press button in memory, press the button that you assigned a long press
button to (the button held down in Step 2). The LED will now go off indicating the new
information has been stored.
Note: These steps must be repeated for each button you would like to assign a dual
purpose feature to. To reset a button back to its default state, repeat Step 1, and then
press the Volume-Down button. The LED will go out, and the long press mapping for
that button will be erased.
Continued on the next page
7
REV. 4/23/24 INSTAXDIS-TY2