Create Wind Round Manual De Instrucciones página 13

B L AD E AS SE MB LY
Align the holes in the blade bracket with the holes in the blades and motor body and screw
them into place, but do not tighten the screws until they are all in place and screwed down.
Advice: To save time, you can place the washers on each screw before installing the blades.
C O NNECTION PANE L AS SE MB LY
• Attach the plate to the bottom of the fan by inserting
the screw heads into the holes provided.
• Then screw in the screws and then secure them so
that they are securely fastened.
LIGH T AS SE MB LY
• Connect the single pin sockets on the breakout board to those on the LED panel. The LED
panel is magnetized so it attaches to the connection board by simply putting both pieces
together.
Note: While installing or removing the LED board, be careful not to touch the insulating tabs.
Do not overtighten the screws or thread them too quickly as this could cause damage to the
insulating tabs.
• Place the decorative screen on the LED board.
ENGLISH
13