Power Ratings; Product Specifications - Craftsman 580.750400 Manual De Usuario

ENGINE TECHNICAL iNFORMATiON
This is a single cylinder, air cooled Model 090000 engine.
The Emission Control System for this pressure washer is
warranted for standards set by the Environmental Protection
Agency and the California Air Resources Board. Certification
does not grant the purchaser, owner or operator of this
engine any additional warranties with respect to the
performance or operational life of this engine. The engine is
warranted solely according to the product and emissions
warranties stated elsewhere in this manual.
Power Ratings
The gross power rating for individual gasoline engine models
is labeled in accordancewith SAE (Society of Automotive
Engineers) code J1940 Small Engine Power & Torque Rating
Procedure, and is rated in accordance with SAE J1995.
Torque values are derived at 2600 RPM for those engines
with "rpm" called out on the label and 3060 RPM for all
others; horsepower values are derived at 3600 RPM The
gross power curves can be viewed at
www.BRIGGSandSTRATTON.COM Net power values are
taken with exhaust and air cleaner installed whereas gross
power values are collected without these attachments. Actual
gross engine power will be higher than net engine power and
is affected by, among other things, ambient operating
conditions and engineoto-enginevariability. Given the wide
array of products on which engines are placed, the gasoline
engine may not developthe rated gross power when used in
a given piece of power equipment. This difference is due to a
variety of factors including, but not limited to. the variety of
engine components (air cleaner, exhaust, charging, cooling,
carburetor, fuel pump, etc.), application imitations, ambient
operating conditions (temperature, humidity, altitudek and
engine_toengine variability. Due to manufacturing and
capacity limitations, Briggs & Stratton may substitute an
engine of higher rated power for this engine.
PRODUCT SPECiFiCATiONS
Pressure Washer Specificatiens
Outlet Pressure .......................... 2,200 PSi*
Flow Rate................................. 1.9 GPM
Detergent Mix ........................ Use as directed
Water Supply Temperature .......... Not to exceed 100°F
Engine Specificatiens
Bore .............................. 2.495 in. (63.4 mm)
Stroke ............................ 1.75 in. (44.45 mm)
Displacement ......................... 8.64 in. (140 cc)
SparkPlug
Type: ...................... Briggs & Stratton 692051
SetGapTo: ...................... 0.020 in. (0.50 mm)
Armature Air Gap: .......... 0.006-0.014 in.(0.15-0.36mm)
Valveclearancewith valve springs installedand piston 1/'4in.
(6 mm) past top deadcenter (checkwhen engine is cold).
Intake .................... 0.004°0.008in.(O.lO-02Omm)
Exhaust .................. 0.004°0.008in.(0.10o020 mm)
FuelCapacity............................... 0.8 Quarts
Oil Capacity....................... 15 Ounces(0.44 liter)
HOTICE For practical operation, the engine load should not
exceed85% of rated power. Engine power will decrease
3-1/2% for each 1,000 feet (300 meters) above sea level and
1% for each 10° F (5.6° C) above 77° F (25° C). it should
operate satisfactorily at an angle up to 15°.
This pressure washer is rated in accordanceto the
Pressure Washer Manufacturers Association (PWMA)
standard PW101o2010_Testingand Rating Performance of
Pressure Washersk
15