Carburetor Adjustment; Aftereachuse - Craftsman 580.750400 Manual De Usuario

Air CoolingSystem
Over time debris may accumulate in cylinder cooling fins and
cannot be observed without partial engine disassembly. For
this reason, we recommend you have a qualified Sears
service dealer clean the cooling system per recommended
intervals (see MaintenanceSchedu/e). Equally important is to
keep top of engine free from debris. See CieanDebris.
Carburetor Adjustment
The carburetor on this engine is low emission, it is equipped
with a non-adjustable idle mixture valve. Top speed has been
set at the factory, if adjustment is required, see an authorized
service dealer.
CAUTION Excessively high operating speeds could
result in minor injury.
Excessively low operating speeds impose a heavy load.
, DO NOTtamper with governor spring, links or other parts to
increase engine speed. Pressure washer supplies correct rated
pressure and flow when running at governed speed.
DO NOTmodify pressure washer in any way.
AFTEREACHUSE
Water should not remain in the unit for long periods of time.
Sediments or minerals can deposit on pump pars and
"freeze" pump action. Follow these procedures after every
use:
1. Shut off engine, turn off water supply, point gun in a
safe direction, press red button and squeezetrigger to
relievetrapped pressure and let engine cool.
,a, WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
ALWAYS pointspraygun in safedirection,pressredbutton
andsqueeze sprayguntriggerto release highpressure, e very
time youstop engine.
2. Disconnect hose from spray gun and high pressure
outlet on pump. Drainwater from hose, gun, and nozzle
extension. Use a rag to wipe off the hose.
3. Placethe spray gun and nozzle extension in the
accessorytray. Hang high pressure hose on hook
attachedto accessory tray.
4. Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most liquid in
pump.
5. Store unit in a clean, dry area.
6. if storing for more than 30 days see Long Term Storage
on next page.
WARNING Fueland its vapors are extremelyflammable
and explosivewhich could causeburns,
fire or explosion resulting in deathor
serious injury.
WHENSTORING FUELOREQUIPMENT WITH FUELiN TANK
* Store away from furnaces, stoves, water heaters, clothes
dryers, or other appliancesthat have pilot light or other ignition
source becausethey could ignite fuel vapors,
2O