Publicidad
Idiomas disponibles
Idiomas disponibles
3b. Wall-mounted installation
Mount the unit on the wall. The unit must be installed in the equipment
room (dry, mild conditions, ventilated). Caution, acid vapours can
cause irreversible damage to your device. Position the treatment
product tanks accordingly.
Unplug the pool filter pump before you begin the installation. The
installation must be performed in compliance with the regulations in
effect in the country of installation.
The AquaRite
UV LS must be fitted a minimum horizontal distance of
®
3.5 m (or more, if required by local regulations) from the pool, within
1 m of a protected outlet and within 4.5 m of the planned cell location.
The unit must be placed vertically on a flat surface, with the cables
downwards. As this box is also used to evacuate heat (heat dissipation
from internal components), it is important that the four sides of the box
remain unobstructed. Do not install the AquaRite
panel or in an enclosed space.
Before installing the unit in the intended location, check that the power
cord can reach the protected outlet and that the cell cable can reach
the intended cell location.
All the metal components of the swimming pool can be connected to
the same earth as per local regulations.
3c. Installation and connection of the electronic circuit boards
Connect the AquaRite
UV LS to a permanent power outlet.
®
•
: This circuit must be protected by a residual current device
(RCD) (residual current: 30 mA max.)
and a 16A time-delay circuit-breaker.
1
®
3 4 5 6 7
2
G
F
C
E
B
D
A
AquaRite
UV LS
®
Only use spare parts supplied by Hayward brands
(x4)
UV LS behind a
8 9 10 11
12
13
14
15
H
I
J
K
L
M
Page 6 on 22
Remove the white lid by
unscrewing the 4 screws
using a screwdriver.
26
25
16
17
18
19
20
21 22 23
24
V
U
N
O
R
S
T
P
Q
®
Publicidad
