Husqvarna 525LK Manual Del Usuario página 8

3. Press the throttle trigger lockout and make sure that
it returns to its intial position when you release it.
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
5. Start the product (refer to the instructions under
start the product on page 15 ) and apply full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
page 17 .
To do a check of the stop switch
1. Start the engine.
8
2. Move the stop switch to the stop position and make
To do a check of the cutting attachment guard
To
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It
also prevents injuries that occur if you touch the cutting
Maintenance on
attachment.
1. Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
To do a check of the vibration damping system
The vibration damping system decreases vibration in
the handles to a minimum which makes the operation
sure that the engine stops.
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Accessories on page 22 .
Refer to,
WARNING:
recommended cutting attachment guard for
the cutting attachment that you use. If an
incorrect or faulty cutting attachment guard
is fitted this can cause serious personal
injury. Refer to,
damaged.
WARNING:
cord or an incorrect cutting attachment
increases the level of vibration.
Do not use a cutting
Always use the
Technical data on page 21 .
Use of incorrectly wound
1027 - 004 - 13.03.2024