Replacing the blades
3. Remove the old blades (20).
4. Refasten the new blades (20) with the
blade bolts (19).
Removing blockages
Wear safety gloves.
There is a risk of injury.
1. Turn the lawn mower over.
2. Open the battery compartment (31) by
removing the 4 screws on the under-
side of the device.
3. Remove the battery (32).
4. Remove the blockage.
5. Reinsert the battery (32).
6. Close the battery compartment (31).
Storage
• Store the device in a dry place, out of
reach of children.
• Do not enclose the device in nylon
sacks as this may cause moisture to
form.
We are not liable for damage cause by
our devices if this is caused by improper
repair, the use of non-original parts or in-
correct use.
Storage over winter
We offer a winter service. Find out
more on our website:
www.grizzlytools.de/service/maehroboter-
winterdienst
• Clean the device prior to storage (see
"Cleaning and maintenance").
• Only store the battery when it is in a
partially-charged state. The charge sta-
tus should amount to 40-60% during a
lengthy storage period.
• Check the battery charge status ap-
proximately every 3 months during
a prolonged storage period and re-
charge if necessary.
• Disconnect the charging station from
the boundary wire
• Insulate the contacts of the boundary
wire with adhesive tape.
If you are starting the device after
an extended storage period, clean
the battery contacts on the device and the
charging prongs (
station with a brass brush to prevent charg-
ing problems.
Transport
(Fig
)
A carrying handle (8) for transporting the
device is located on the rear of the lawn
mower.
Always carry the lawn mow-
er with the blades (20) point-
ing away from your body.
Risk of injury!
Disposal and protection
of the environment
Remove the battery from the device and
recycle the battery and packaging in an
environmentally-friendly manner. Dispose
of the packaging material properly.
Electrical appliances must not be
disposed of with the domestic
waste
GB MT
29) on the charging
65