CEMO DT-Mobil Easy 980I Manual De Instrucciones página 42

GB
13. Additional tank with electric
pump and delivery nozzle for AUS
32 urea solution (DT-Mobil Easy
COMBI version)
13.1 Layout
B B
DT-Mobil Easy COMBI 850/100 Premium
13.2 Technical data
13.2.1 Additional tank for AUS 32
Dimensions L x W x H mm: 772 x 589 x 484
Nominal volume: 100 l
13.2.2 Pump 12 V
Voltage:
Fuse:
Power:
Delivery rate:
max. delivery pressure:
Liquid temperature:
13.3 Electrical connection of the pump
see operating instructions for the pump, section 5
42
D D C C
12 VDC
25 A (at the pole terminal)
220 W
approx. 25 l/min
1.1 bar
-5 °C to +40 °C
13.4 Initial setup
Unscrew the cap of filling opening
terior of the container for contamination and clean
it if necessary, e.g. with a vacuum cleaner.
Refill the container using a delivery nozzle with
an automatic shut-off. After refilling, screw the cap
back on the filling opening.
Make sure that the pump is switched off. Connect
the terminal clamps to a suitable voltage source
and switch on the pump at the switch.
Please note:
Despite increased caution, contaminants may
have entered the system during assembly of the in-
dividual parts. Due to the high purity requirements
during set-up, we therefore recommend that the
first 5 litres, approximately, are not used to fill the
vehicle, but are collected separately.
The filling station is now ready for operation.
13.5 Use
13.5.1 Refuelling vehicles/filling contain-
ers
Take delivery nozzle
C C
insert the delivery spout into the container/tank to
be filled.
Connect the power supply and switch on the pump
at switch .
D D
To dispense urea solution, now pull the actuating
lever of the delivery nozzle and, if necessary, slot
the small flap below the lever into the toothing at
the desired level. The delivery nozzle switches
off automatically when the container/tank of the
vehicle to be refuelled is full. If you wish to stop
dispensing before the tank is full, pull the level
briefly to disengage and release it.
After the delivery spout has drained, remove the
nozzle from the filler neck and roll up the hose.
Place the delivery nozzle back in the holder. Shut
off the pump.
Never let the pump run dry for a prolonged period
of time if the container is empty. It can only be
safely run dry on a limited basis and can be dam-
aged by overheating.
Do not kink the delivery hose when refuelling and
winding it onto the container.
Important: The refuelling process must be super-
vised at all times.
Please note: Container ventilation and pressure
relief are performed automatically by
integrated valve
. Check the in-
B B
out of the holder and fully
.
B B