cecotec BOLERO SQUAD I 3250 Manual De Instrucciones página 72

ENGLISH
Dirt on the 1. Unplug the induction hob
touch controls
2. Absorb the spill.
3. Clean the touch control area
4. Dry the area completely with
5. Reconnect the hob to the
6. TROUBLESHOOTING
Problem
The induction hob
does not turn on
The touch icons
do not work
It is difficult to use
the touch icons
The glass is
damaged
Some cookware
makes crackling
or popping noises
72
BOLERO SQUAD I 3250
from the mains.
with a sponge or a damp and
clean cloth.
a paper towel.
mains if you wish to continue
using it.
Possible causes
There is no power supply
The icons are locked.
There may be a slight film of
water on the buttons, or you
may be using your fingertip to
press the buttons.
Cookware with rough edges.
Use of inappropriate and
abrasive scouring pads or
cleaning products.
This may be due to the
construction of your cookware
(layers of different metals that
vibrate differently).
The induction hob may beep and turn
off, and the touch controls will not
work while there is liquid on them.
Make sure you dry the touch control
area before turning on the hob again.
Possible solution
Make sure the hob is connected to the
mains and it is on.
Check if there has been a power
failure. If the problem persists, please
contact the official Cecotec Technical
Support Service.
Unlock the icons. Check the 'Buttons
lock' section for instructions.
Make sure the touch control area is
dry and use your finger base to press
the buttons.
Use cookware with flat and smooth
bases. Check the 'Selection of the
suitable cookware' section. Check the
'Cleaning and maintenance' section.
This is normal for cookware and does
not indicate a fault.