Publicidad
Idiomas disponibles
Idiomas disponibles
ELITE 2000
4.3
HIGH PRESSURE HOSE AND SPRAY GUN (C)
1. Screw the high pressure hose (9) onto the hose connection
2. Screw the spray gun (10) onto the high pressure hose
3. Tighten all union nuts on high pressure hose so that no
coating material can escape.
4. Screw the tip guard with the selected tip onto the spray
gun, align tip and tighten union nut.
5. Fully depress the pusher stem (11) to make sure the inlet
ball is free.
C
11
9
When unscrewing the high pressure hose, hold
firmly on the hose connection with a 22mm
wrench.
Attention
4.4
CONNECTING TO POWER
Connection must always be carried out via
an appropriately grounded safety outlet with
residual-current-operated circuit-breaker.
Attention
Before connecting the unit to the mains supply, ensure that the
line voltage matches that specified on the unit's rating plate.
10
4.5
PURGING CLEANING SOLUTION DURING
START UP
UNIT WITH SUCTION TUBE
1. Immerse the suction system into a container filled with a
suitable cleaning agent (recommendation: water).
UNIT WITH OPTIONAL HOPPER
2. Fill up hopper with a suitable cleaning agent
(recommendation: water).
3. Set pressure relief valve (1) to
4. Switch the pump ON (Pos. I) using the ON/OFF switch (2).
5. Slowly turn the pressure control knob (3) clockwise.
6. Wait until you can hear the sound of the inlet valve and
cleaning agent flows from the return hose.
7. Turn the pressure control knob (3) back approx. one
rotation.
8. Set
pressure
relief
Pressure will increase inside the high pressure hose .
9. Point the tip of the spray gun to inner wall of an open and
empty metal container and pull the trigger at the spray
gun.
10. The pressure is increased by turning the pressure control
knob (3) to the right.
11. Spray the cleaning solution out of the unit for approx.
1 - 2 min. (~0.25 gal.) into the open collecting container.
2
STARTUP
( circulation).
valve
(1)
to
(spray).
3
1
11
Publicidad
