Publicidad
Idiomas disponibles
Idiomas disponibles
ELITE 2000
C
25 - 30 cm
If very sharp edges result or if there are streaks in
i
the spray jet – increase the operating pressure or
dilute the coating material.
5.1
CLEANING A CLOGGED TIP
If the spray pattern becomes distorted or stops
i
completely while pulling the trigger, perform the
steps below.
1. Turn the relief valve to PRIME (
2. If the tip clogs, rotate the tip handle 180° until the arrow
on the handle is facing the opposite of the spray direction
and the handle clicks in the reverse position.
3. Turn the relief valve to SPRAY (
4. Trigger the gun once so that the pressure can blow the
clog out. NEVER use the tip in the reverse position for
more than ONE trigger pull at a time. This procedure can
be repeated until the tip is free of clogging.
The flow from the spray tip is at very high pressure.
Contact with any body part may be dangerous.
Do not place finger on gun outlet. Do not point
the gun at any person. Never operate the spray
gun without the proper tip guard.
25 - 30 cm
circulation).
spray).
SPRAYING TECHNIQUE / HANDING THE HIGH PRESSURE HOSE
6
HANDLING THE HIGH-PRESSURE HOSE
The unit is equipped with a high-pressure hose specially suited
for diaphragm pumps.
Danger of injury through leaking high-pressure
hose. Replace any damaged high-pressure hose
immediately.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against sharp
objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Titan spray gun with a swivel joint and a
hose system.
When using the high-pressure hose while
i
working on scaffolding, it is best to always guide
the hose along the outside of the scaffolding.
The risk of damage rises with the age of the high-
i
pressure hose.
Titan recommends replacing high-pressure
hoses after 6 years.
Only use TITAN original-high-pressure hoses with
i
internal heating in order to ensure functionality,
safety and durability.
13
Publicidad
