Publicidad
Idiomas disponibles
Idiomas disponibles
____________________________________________________________________
Description of the product
Barking
detection
sensitivity
setting screw
Screwdriver
____________________________________________________________________
Activate/deactivate the collar
Activate:
‒ unscrew the 4 screws of the battery cover.
‒ Insert the battery (3 Volts Lithium CR2) paying attention to follow polarity
indicated on the battery housing. A beep sound is emitted indicating the collar
is ready for use.
If you do not hear any sound beep after inserting the battery, immediately
remove it from its housing. Check the polarity before inserting it once again.
‒ Check that the rubber seal is in its place in the groove of the battery cover.
‒ Re-tighten moderately the 4 screws.
Deactivate: remove the battery from its housing.
____________________________________________________________________
Changing operating mode
In the factory, the collar is set at mode 2 (beep sounds + light stimulations).
To change the mode, you should proceed as follows:
‒ The collar must be ready for use (battery in place).
‒ Open the battery cover and find the button to change mode (See diagram).
‒ Press the button using a pointed object (e.g. a screwdriver).
‒ A series of sound beeps is emitted (from 1 to 4 beeps) indicating the selected
mode. Keep pressing the button to run through modes.
‒ Release the button when you have reached the mode you wish.
‒ The collar will memorize your selected mode. Next time you will switch on the
collar, your collar will be turned on to the last mode you previously selected.
Guide d'utilisation CANICALM ULTRA- NUM'AXES Education – Avril 2024 – ind. A - 11/48
–
polarity of the battery
Push-button to change
operating mode and
check battery level
polarity of the battery
Publicidad
