Num'axes EDUCATION CANICALM ULTRA Manual De Instrucciones página 13

____________________________________________________________________
Checking and replacing battery
To check the battery condition, you have to press the operating mode push-button.
If the collar emits a continuous beep sound when you press the button, the battery is
weak. Prepare to replace it. When the battery is completely exhausted, the product
goes to safety mode, which means it is out of use. You need to replace the battery
with a new one.
NOTE: due to greater use during your dog's training, the first battery may not last
as long as the following ones.
You need to replace the used battery by a new one of the same type (3 volts CR2
lithium battery). Proceed as follows:
‒ Remove the 4 screws from the battery cover.
‒ Remove the battery cover then remove the old battery.
‒ Insert the new battery paying attention to the polarity indicated on the battery
housing. A sound beep is emitted indicating the collar is ready to use.
If you do not hear any sound beep after inserting the battery, immediately
remove it from its housing. Check the polarity before inserting it once again.
‒ Replace the battery cover and retighten moderately the 4 screws.
The NUM'AXES Group advises to use the same type and same brand of batteries as
the one supplied in your new purchased product. Other brands of batteries may not
operate, or may not be completely compatible with your product.
You can purchase suitable batteries at any time on www.numaxes.com.
____________________________________________________________________
Changing the contact points
Two different series of contact points are supplied. The length of the contact points
must be sufficient to have proper contact with the dog's skin, enabling the device to
operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the
factory are inadequate, remove and replace them with the long contact points
supplied with the kit. A moderate manual screwing is sufficient (do not use any key).
____________________________________________________________________
Strap adjustment
The strap should be adjusted so that the contact points come right into contact with
the dog's skin in order to ensure good barking detection.
If the strap is too loose, the collar will not operate properly. Moreover, it might move
around the dog's neck and repeated rubbing of the contact points on the skin can
cause irritation.
If the strap is too tight, the dog will have difficulties in breathing.
Guide d'utilisation CANICALM ULTRA- NUM'AXES Education – Avril 2024 – ind. A - 13/48