No.
Malfunction
The water in the Cleaning Sink is
full and cannot be drained out�
19
A voice prompt alerts that the
Cleaning Sink is full�
Mopping Pad Plates can't be
20
lifted automatically�
Possible Causes
The Dirty Water Tank is not properly installed�
The sealing plugs in the Dirty Water Tank are not
installed properly�
The Station cannot drain water normally�
The suction port of the Cleaning Sink is blocked by
foreign objects, or the Cleaning Sink is too dirty�
The voice prompt still exists after trying the above
solutions�
Mopping Pad Plates are entangled or stuck
by foreign objects�
Mopping Pad Plates fall off�
Solutions
Tap down on the Dirty Water Tank to ensure it is properly installed�
Make sure that the sealing plugs are properly installed�
Long press
� After the cleaning Sink has been automatically
filled with water, long press
again� If the problem occurs
during the mopping pads cleaning process, end task by App/Voice
Command, and then long press
properly draw the water� If the water is successfully drawn, wipe dry
the Water Overflow Sensor of the Cleaning Sink� If the Station fails to
draw the water, check between the Dirty Water Tank and the Station
for foreign objects and clean them out�
Ensure that there is no foreign object in the suction port of the
Cleaning Sink� Clean up the Cleaning Sink�
Unplug the Station and plug it in again� If this problem persists,
please contact Customer Care for help�
Please remove foreign objects�
Reinstall the Mopping Pad Plates and you would hear a "click" when
the Mopping Pad Plates are properly installed�
to see whether the Station can
29 EN