ECOVACS DEEBOT T30S Manual De Instrucciones página 7

Increase the separation between the equipment and
receiver�
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected�
Consult the dealer or an experienced radio/TV
technician for help�
This device complies with Part 15 of the FCC Rules�
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation�
Caution: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment�
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt
RSS(s)� Operation is subject to the following two
conditions:
(1) This device may not cause interference�
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device�
RF exposure warning
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment�
This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons
and must not be collocated or operating in conjunction
with any other antenna or transmitter�
MPE caution (for mobile device under Part 15�247 &
15�407 device)
To satisfy FCC & ICRF exposure requirements, a
separation distance of 20 cm or moreshould be
maintained between the antenna of this device and
persons during device operation�
To ensure compliance, operations at closer than this
distance is not recommended�
To disable the Wi-Fi module on DEEBOT, follow these
steps: power on the robot, then place it on the OMNI
Station, ensuring that the Charging Contacts on DEEBOT
and the Station are properly connected� Double-tap the
button�
To enable the Wi-Fi module on DEEBOT, please restart
the robot� Additionally, unplug and plug in the Station�
SAVE THESE INSTRUCTIONS
7 EN