Audi youngster plus Instrucciones página 15

4L0019902_903A_Buch_1.book Seite 17 Freitag, 15. Juni 2012 10:51 10
Figure N
► Insert the cover into the child seat from the top
■ Make sure that the cover is pushed beneath the top part of the gui-
de plate
■ Adjusting the guide plate makes removal easier
■ To do this, read chapter 7.2 Adjusting the belt height (head res-
traint) on page 15.
► Carefully push the latch plates (11) through the corresponding ope-
nings in the cover and pull them with the belts through the cover
WARNING
Danger to life!
The belts must not be twisted and must remain flat. A twisted belt
could cause serious or fatal injury to a child in an accident.
► Pull the two latch plates (11) through the two lap pads (17) and push
them up to the end of the belt (towards the child seat)
► Push the belt buckle down through the cover padding
► Pull the tensioning belt (10) through the corresponding cover ope-
ning and fasten it to the push button
► Pull the clamping lips over the edge of the child seat
Figure L
► Bring the two latch plates together and clip them in the belt buckle
► Carefully pull the fabric pockets at the top and bottom of the head
restraint cover over the guide plate
► Insert the two joined shoulder strap pads from behind through the
openings on the height adjuster (13) and on the head restraint cover;
the shoulder pad belt should lie over the bolts of the height adjuster
(13) and the rubber-coated surfaces of the shoulder strap pad
should face downwards.
► Guide the shoulder pad belt beneath the four hooks on the height
adjuster (13)
► Guide the shoulder strap loops from the front through the shoulder
pad, the two openings in the head restraint cover and the belt ope-
nings in the child seat
■ Make sure that the belt is above the head restraint height adjuster
and the shoulder pad belt
17
► Hook the belts (9) using the shoulder strap loops into the connecting
plate (14)
► Carefully pull the fabric pockets at the top and bottom of the head
restraint cover over the guide plate
► Tighten the belts (9) evenly using the tensioning belt (10)
■ To do this, read chapter 7.4 Tightening the belts on page 15.
9 Notes regarding disposal
ENVIRONMENT
Type and source of the hazard!
The table below lists the options for disposing of the used child
seat materials. Always observe the disposal regulations applicable
for your country.
Packaging Container for cardboard
Cover Residual waste, thermal recycling
Plastic parts Appropriate marking in the containers provided
10 Follow-on seat
You will need to change to the next seat size up when the crown of
your child's head is above the top edge of the child seat when the
seat belt adjuster is in the uppermost position.
The follow-on seats can be found below.
4 L0 019 904 A Audi youngster plus
4 L0 019 905 A
EN