Publicidad
Idiomas disponibles
Idiomas disponibles
Standard assembly
Insert the inspection cover [ 1 ] into the
inlet pipe [ 26 ] and screw it in by hand
(1).
Pull the sealing ring [ 6 ]
of the inlet pipe [ 26 ] and push
spigot
it up to edge
of the bead
Push the entire width of the sealing
sleeve [ 3 ] and connector [ 2 ] loosely
over the connection port [ 8 ] of the upper
section (3).
Stud bolts [ 9 ] are mounted on the
upper section on delivery.
Insert the inlet pipe [ 26 ] into the opening
of the upper section (note possible
positioning of the inlet fitting). Place the
holes over the stud bolts [ 9 ] .
Connect the screw joints
[ 9 ] , washer [ 5 ] and nut [ 4 ] ).
Push the sealing sleeve [ 3 ] and the
connector [ 2 ] half way onto the
connection port of the inlet pipe and
tighten the screws of the connector by
hand.
LipuJet - P -RB / - RD / - RM / - RA / - RAP
over the
(2).
(stud bolt
Installation
3.
1.
2.
71/ 454
Publicidad
