ACO LipuJet P-RB Instrucciones De Empleo página 79

Insert the high-pressure nozzle with the
drive shaft [ 5 ] into the opening
upper section.
Seal the high-pressure nozzle with the
connecting flange [ 4 ] into the threaded
sleeve of the opening (e.g. with Teflon
plus Loctite 577) and tighten by hand.
IMPORTANT
The nozzle [ 6 ] should be approx. 150 mm
above the zero water line (pipe bottom of
the outlet socket) of the grease separator, if
necessary readjust the position of the drive
shaft [ 5 ] via the split connection flange
using the clamping ring [ 4 ] .
2.7 High-pressure pump assembly
2.7.1 Components
1 = Bracket mounted on HP pump
2 = High-pressure pump (HP pump)
LipuJet - P -RB / - RD / - RM / - RA / - RAP
in the
1
2
3
4
3 = Suction hose connection
4 = Connecting flange for high-pressure hose
Installation
79/ 454