Publicidad
Idiomas disponibles
Idiomas disponibles
LipuJet - P -RB / - RD / - RM / - RA / - RAP
Installation
17 = Stud bolt
18 = Sealing
19 = Pressure elbow
2.15.2 Position
2.15.3 Assembly
The opening
bottom part: The opening is open and
the stud bolts [ 10 ] are mounted.
Push the socket seal [ 11 ] into the
opening as far as it will go (1).
The following parts are mounted as a
single assembly on delivery: Disposal
pump [ 16 ] , stop valve [ 15 ] , flange
[ 13 ] and submersible pipe [ 12 ]
Push the assembly through the opening
until the flange [ 13 ] touches the
bottom section. Drill flange holes over
the stud bolts [ 10 ] . Slide the washers
[ 14 ] over the stud bolts [ 10 ] . Screw the
nuts [ 14 ] onto the stud bolts [ 10 ] and
tighten them crosswise by hand (2).
96/ 454
The direct suction unit with disposal
pump can be positioned to the
right
or left
of the centre axis of
the tank.
Assembly on the left
below.
Heaviest single component or assembly approx. 65 kg.
Numbers in brackets " [ ] ",
"Components".
is pre-prepared in the
20 = Nut
21 = Washer
22 = Elbow gland
described
Representation of the components _ Chap. 2.15.1
2.
1.
Publicidad
