Toshiba Carrier RBC-AXU33CP-UL Manual De Funcionamiento página 8

5
Operating unit
■
Cooling / Heating / fan only
operation
Start
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool
3
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY
operation, the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
, MED
+
The OPERATION lamp on the display panel of
●
the indoor unit goes on. And operation starts after
approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
The : Fan only mode does not control
●
temperature.
Fan speed
●
HIGH
Therefore, perform only steps
this mode.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with
a cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
7-EN
SWING FAN
)
, Heat , or Fan only
)
LOW , LOW , MED
+
, HIGH
is the same as
.
1 2 4
. and
)
■
Dry operation
Start
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Dry
3
Temperature button (
Set the desired temperature.
The fan speed display indicates
●
The
●
of the indoor unit lights, and operation starts after
approximately 3 minutes.
.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
to select
– 7 –
SWING FAN
)
OPERATION lamp on the display panel
)
)
.