Create Wind Stylance Manual De Instrucciones página 14

DECOR AT IV E C OV E R AS SE M B LY
* Only for the model WITHOUT LIGHT
Once the connections plate has been assembled and secured, screw the decorative cover back
to the connections plate using the central screw.
LIGH T AS SE MB LY
* Only for the model WITH LIGHT
Connect the single-pin plugs of the connections plate with the ones on the LED panel. The
LED panel is magnetized so it will be attached to the connections panel just by placing
them together.
Note: While installing or removing the LED plate, please keep the insulation pads intact
carefully. Turning the set screws over-tightly or fast will damage the insulation pads.
Screw the lamp shade back to the connections plate.
C HECK TH E I NSTALL AT I O N
• Check the correct operation of the ceiling fan, checking that no strange movement or misalign-
ment is observed in any part of the fan.
• In the event that some kind of hum / vibration can be seen, you can proceed to adjust the blades
with the shooting kit.
• This kit has self-adhesive weights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip to a differ-
ent blade or use the adhesive weights.
E NGL I SH
14
Single-pin plug
LED panel