Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
www.domo-elektro.be
again.
•
After the programme has stopped, the blender will automatically return to stand
by mode.
CLEANING & MAINTENANCE
•
Carefully remove the plug from the socket.
•
Never immerse the motor base, motor unit or the power supply cord in water or
any other liquid.
•
Clean the surface of the jar with a soft cloth or a sponge. The measuring cup and
lid should be removed from the device for easier cleaning.
•
The jar may be cleaned with water. You could also clean it by pouring two glasses
of pure water in the jar, placing the lid on top and using the pulse function on the
blender. Afterwards pour out the water and dry off the jar with a soft cloth.
•
After cleaning you are best to place the jar on its head or sideways, to prevent
standing water to create rust on the motor unit where it connects with the jar. This
could result in the device not working as well as before.
NOTE SURROUNDING USAGE
•
Never use the device in the following situations:
•
When the jar hasn't been correctly placed on the motor unit.
•
When the control knob has selected a speed setting before the jar has
been placed correctly onto the motor unit.
•
When the jar has been taken off the motor unit and simply put back in
place. You are required to first turn the control knob in its OFF position
before placing the jar correctly on the motor unit. Only then will the
blender be safe for use.
•
When the motor is turning slowly and the food's consistency is too thick or
there's not enough fluid present in the jar, the motor will get too hot when used
for a long while. This could trigger the overheat protection. The red LED light
will blink. Should this happen, you need to remove the plug from the socket
carefully and let the device cool off for about 45 minutes. Afterwards you can use
the device again.
•
When blending hot beverages like soups or sauces, we advise you to start at a low
speed setting and gradually increase the speed, or to use the pulse function.
•
First start by adding liquids or soft foods before adding the hard foods or ice
cubes.
•
When you are done with blending, wait until the blades have entirely stopped
turning before removing the jar from the motor unit. If you do not, the motor unit
might end up damaged.
•
If you smell something burnt, immediately stop the device. The rubber on the
motor unit might be the cause, if it was not installed properly
•
When using thick or sticky foods at high speeds, you are best to start at a low
43
DO486BL
Publicidad
Tabla de contenido
