YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 15

WARNING
around the drive, motor, and machine and attach covers, couplings, shaft keys, and machine loads before
you energize the drive. If personnel are too close or if there are missing parts, it can cause serious injury
or death.
WARNING
drive. Operate the drive in the specified range of the input voltage on the drive nameplate. Voltages that
are higher than the permitted nameplate tolerance can cause damage to the drive.
WARNING
do not install the drive near flammable or combustible materials. Attach the drive to metal or other
noncombustible material. Flammable and combustible materials can start a fire and cause serious injury
or death.
WARNING
Connections that are too loose or too tight can cause incorrect operation and damage to the drive.
Incorrect connections can also cause death or serious injury from fire.
WARNING
manual. If you tighten the screws at an angle not in the specified range, you can have loose connections
that can cause damage to the terminal block or start a fire and cause serious injury or death.
WARNING
short circuit on the output can cause serious injury or death.
WARNING
conductor, the drive can cause a residual current. When a residual current operated protective or
monitoring device prevents direct or indirect contact, always use a type B Residual Current Monitor/
Residual Current Device (RCM/RCD) as specified by IEC/EN 60755. If you do not use the correct RCM/
RCD, it can cause serious injury or death.
WARNING
models BxxxE, 2xxxE, and 4xxxE to comply with the EMC Directive before you turn on the EMC filter or if
there is high resistance grounding. If you turn ON the EMC filter, but you do not ground the neutral point, it
can cause serious injury or death.
WARNING
you wire the drive and set parameters. If you do not test the system, it can cause damage to equipment or
serious injury or death.
WARNING
immediately energize the drive or operate peripheral devices. Wait for the time specified on the warning
label at a minimum and make sure that all indicators are OFF. Then check the wiring and peripheral device
ratings to find the cause of the problem. If you do not know the cause of the problem, contact Yaskawa
before you energize the drive or peripheral devices. If you do not fix the problem before you operate the
drive or peripheral devices, it can cause serious injury or death.
WARNING
applicable codes and this manual. The drive is suited for circuits that supply not more than 31,000 RMS
symmetrical amperes, 240 Vac maximum (200 V Class), 480 Vac maximum (400 V Class). Incorrect
branch circuit short circuit protection can cause serious injury or death.
CAUTION
move the drive. If the drive or covers fall, it can cause moderate injury.
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction
Sudden Movement Hazard. Remove all personnel and objects from the area
Damage to Equipment. Do not apply incorrect voltage to the main circuit of the
Fire Hazard. Do not put flammable or combustible materials on top of the drive and
Fire Hazard. Tighten all terminal screws to the correct tightening torque.
Fire Hazard. Tighten screws at an angle in the specified range shown in this
Electrical Shock Hazard. Do not cause a short circuit on the drive output circuit. A
Electrical Shock Hazard. When there is a DC component in the protective earthing
Electrical Shock Hazard. Ground the neutral point on the power supply of drive
Crush Hazard. Test the system to make sure that the drive operates safely after
Electrical Shock Hazard. After the drive blows a fuse or trips an RCM/RCD, do not
Fire Hazard. Install sufficient branch circuit short circuit protection as specified by
Crush Hazard. Tighten terminal cover screws and hold the case safely when you
1 English
15