YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 16

1 English
CAUTION
minimum of 15 minutes, then make sure that the heatsink is cool before you replace the cooling fans. If
you touch a hot drive heatsink, it can burn you.
NOTICE
that you observe correct electrostatic discharge (ESD) procedures. If you do not follow procedures, it can
cause ESD damage to the drive circuitry.
NOTICE
drive is outputting voltage. Incorrect equipment sequencing can cause damage to the drive.
NOTICE
or megger insulation tester on the drive. These tests can cause damage to the drive.
NOTICE
You can cause damage to the drive and connected equipment.
NOTICE
(RCM/RCD). If you do not install these components, it can cause damage to the drive and connected
equipment.
NOTICE
make sure that qualified personnel read and obey the Braking Unit and Braking Resistor Unit Installation
Manual (TOBPC72060001). If you do not read and obey the manual or if personnel are not qualified, it can
cause damage to the drive and braking circuit.
NOTICE
peripheral devices. Incorrect connections can cause damage to the drive.
NOTICE
breakers (RCM/RCD) to the motor circuit. If you connect these devices to the output circuits, it can cause
damage to the drive and connected equipment.
NOTICE
windings applicable for use with an AC drive. If the motor does not have the correct insulation, it can
cause a short circuit or ground fault from insulation deterioration.
Note:
• Do not use unshielded wire for control wiring. Use shielded, twisted-pair wires and ground the shield to the
ground terminal of the drive. Unshielded wire can cause electrical interference and unsatisfactory system
performance.
• Do not put devices that radiate strong electromagnetic waves, for example radio transmitters, near the drive. If
you use these devices near the drive, the drive can operate incorrectly.
■
Intended Use
The drive is a commercial-use electrical device that controls the speed and rotation
direction of a motor. Do not use the drive for any other purpose.
1. Carefully read the technical manual.
2. Read all safety precautions before you install, wire, or operate the drive.
3. When you install the drive, wire and ground it according to all applicable standards
and safety precautions.
4. Make sure that you correctly install all components and protection covers.
16
Burn Hazard. Do not touch a hot drive heatsink. De-energize the drive, wait for a
Damage to Equipment. When you touch the drive and circuit boards, make sure
Do not break the electrical connection between the drive and the motor when the
Damage to Equipment. Do not do a withstand voltage test or use a megohmmeter
Do not operate a drive or connected equipment that has damaged or missing parts.
Fire Hazard. Install a fuse and equipment for residual current monitoring/detection
Damage to Equipment. Before you connect a dynamic braking option to the drive,
Make sure that all connections are correct after you install the drive and connect
Do not connect phase-advancing capacitors, LC/RC noise filters, or leakage
Use an inverter-duty motor or vector-duty motor with reinforced insulation and
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction