Merach MR-R14 Manual Del Usuario página 11

Step 1: Install the left and right rear rail assemblies
1. Remove the main frame assembly(A), left rear rail assembly(B), right rear rail assembly(C),
and screw kit(F) from the carton.
2. Remove the 2 screws(100) as shown in the illustration, and in the direction shown in the
illustration, insert the 2 hexagon socket flat head screws(100) through the left and right rear
rail assembly(B/C) in the corresponding holes and pass through them, and then use a Allen
wrench(101), with a Phillips wrench(103) to put the 2 cap screws, then use a Allen wrench
(101) and a Phillips wrench(103) to lock the two cap screws(95) to the two hexagonal flat
head screws(100).
3. Remove the 2 hexagon socket head cap screws(76) and thread them through the holes in
the top of the left and right rear track assemblies(B/C) and the corresponding 2 cap nuts(95).
Lock it with an Allen wrench(101) and with a Phillips wrench(103).
Note: Do not lock it tightly yet.
4. Use the Allen wrench(101) again to lock the 2 Allen flat head screws(99) through the holes
under the left and right rear track assemblies(B/C) to the track center connection plate(07)
and lock all screw nuts.
Assembly Instruction
Preparation:
1. Before installation, please confirm that there is sufficient
space around the site.
2. Please use the tools provided with the vehicle or your own
special tools for installation.
3. Before installation, confirm that all components are complete.
#95 Cap nuts M8 *4
#100 Hexagon socket flat head conical screws M8×90×S5×15*2
#76 Hexagon socket flat head screws M8×40×15×S5 *2
#99 Hexagon socket flat head screws M8×50×15×S5 *2
#101 Allen wrench S5 30*80*5 S5 *1
#103 Phillips wrench S13 S14 S17 *1
008
EN