Tennant LPTB03379 Manual De Instrucciones página 24

5.5.3. Batteries: removal
When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
disconnect the battery wiring and bridge terminals from the battery poles.
if necessary, remove the devices fixing the battery to the base of the machine.
lift the batteries from the compartment using suitable lifting equipment.
5.6. Battery charger (battery models)
Never allow the batteries to become excessively flat as this could damage them
5.6.1. Choosing a battery charger
Make sure the battery charger is compatible with the batteries to be charged:
tubular lead batteries: you are recommended to use a 24V - 20 A automatic battery
charger. However, you should always consult the battery charger manufacturer and
manual to confirm the choice.
gel batteries: use a charger specific for this type of battery.
5.6.2. Preparing the battery charger
If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine (see paragraph "Unpacking" in this manual).
The connector supplied for the external battery charger is suitable for cables with a
minimum cross-section of 4 mm2
Proceed as follows to fit the connector.
Remove about 13 mm of protective sheath from the red and black cables of the battery
charger.
Insert the wires into the connector contacts and squeeze them forcefully with suitable
pliers.
Respect the polarity (red wire + black wire –) when inserting the wires into the
connector.
5.7. Lifting and transporting the machine
All phases of lifting and moving must be performed in an adequately illuminated
environment with the adoption of the safety measures most appropriate to the
The operator must always use personal protection devices.
To load the machine onto a means of transport, proceed as follows:
empty the dirty water and detergent tanks;
remove the squeegee and brushes or drive disks;
remove the batteries;
place the machine on the pallet and fix it with plastic straps or metal brackets;
! DANGER
follows:
IMPORTANT
irreparably.
IMPORTANT
situation.
ENGLISH
11