Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Fault/Working
condition problems
High vibration during
the use of equipment
The engine does
not turn on
The engine runs
unstable
Irregular cutting
results
Collector
is not filled
enough
28
TROUBLESHOOTING
Cause
The screws are loose
Blade screw is loose
The blade is unbalanced
Bent blade support shaft
due to a strong impact
Brake lever is not pressed
The spark plug is defective
The cutting blade is worn or damaged
The fuel tank is empty
The engine may be flooded
The air filter is dirty
The spark plug is dirty
The blade is not sharpened
Cutting height is too low
The blade is worn
The grass collector is clogged
Cutting height is incorrect
The lawn/grass is wet
The discharge channel is blocked
The bottom of the mower deck is obstructed
Solution
Check the screws
Check the blade screw
Replace the blade
Replace the blade holder shaft
Press the brake lever
Replace the spark plug
Replace it with a new drive
Refill with fuel
Remove the candle and dry
Clean the air filter
Clean the spark plug
Sharpen the blade
Set the correct height
Replace the blade
Empty the grass collector
Correct the cutting height
Let the lawn dry
Clean the discharge channel
Clean the bottom of the mower deck
Publicidad
