Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4. INTENDED USE
The tool is designed for pruning branches only.
A different use than indicated can damage the tool and cause dangers.
The tool is designed for adult use only, do not use in rainy weather or to work on wet plants or bushes.
The manufacturer is not responsible for damages caused by the nonobservance of the instructions in this manual.
Check the correct tension and sharpening of the chain before using the tool.
Damages caused by the use of not sharpened and / or incorrectly tensioned chain are not covered by the warranty.
5. tool components
Open the packaging carefully and check all the components listed below:
1. Chainsaw
2. 2 batteries
3. Charger
5.1 Display
Percentage of the
battery charge.
Displayed code
E2
E3
E4
E5
E6
NOTA: If the error is not clear, contact a service center.
4. Toolbox
5. Bar cover
6. User's manual
Description
Overvoltage / undervoltage error
Boot failure
Overvoltage fault
NTC open / short circuit fault
Excessive temperature of the mosfet
Displays hours - minutes
Pulling the trigger it starts
the count
1. Displays the seconds
of use.
2. Show error codes.
9
Flashing
Slow
Slow
Slow
Slow
Slow
Publicidad
